亚洲国产精久久久久久久,久久精品视频免费观看,欧美亚洲另类色国产综合,国产精品国产三级国快看

1、加入酒曲時溫度要求：①夏天缸內水溫25-30℃，冬天30-36℃。用溫度計測量缸內水溫，不能憑手感估測，以防溫度過高，將酒曲燙死，引起酸酒或減少出酒量。②發酵溫度：發酵溫度25-35℃，低于20℃發酵不良，需加溫。可用蜂窩煤爐（用管道將煤氣接出室外）或電爐等加溫設備加溫。

1. Temperature requirements for adding yeast: ① The water temperature in the tank is 25-30 ℃ in summer and 30-36 ℃ in winter. Measure the water temperature inside the cylinder with a thermometer, and do not estimate it based on hand feeling, in order to prevent the temperature from being too high and causing the yeast to burn to death, causing sour wine or reducing the alcohol output Fermentation temperature: The fermentation temperature is 25-35 ℃. If it is below 20 ℃, the fermentation is not good and needs to be heated. Heating equipment such as a honeycomb coal furnace (using pipes to connect gas outdoors) or an electric furnace can be used for heating.

2、用水要求：用不帶堿性的泉水或自來水。水質無色、透明、極少懸浮物或沉淀，清爽適口，略有回甜。

2. Water requirements: Use non alkaline spring water or tap water. The water quality is colorless, transparent, with very little suspended solids or sediment, refreshing and palatable, and slightly sweet.

3、為提高酒質，將酒頭（100公斤糧食接酒頭1公斤）和酒尾留下，等下次蒸酒時混合蒸餾。

3. To improve the quality of the wine, leave the wine head (1 kilogram of grain mixed with the wine head) and the wine tail, and mix and distill the next time the wine is steamed.

4、厭氧發酵：特別是中期和后期，要嚴格封缸，厭氧發酵，否則漏氣后引起酒產酸而降低出酒率。

4. Anaerobic fermentation: Especially in the middle and late stages, strict sealing of the tank and anaerobic fermentation should be carried out, otherwise gas leakage can cause acid production in the wine and reduce the yield.

5、糧食混合發酵：①玉米40%，高粱25%，小麥35%；②大米60%，高粱15%，玉米25%，酒質會(huì )更好。

5. Grain mixed fermentation: ① 40% corn, 25% sorghum, 35% wheat; ② 60% rice, 15% sorghum, and 25% corn will improve the quality of the wine.

6、發酵過程。發酵初期：液面布滿氣泡，以后小氣泡大似肥皂泡、原料上下竄動，翻騰酒液變混濁。發酵衰退期：原料漂浮液面氣泡減少，少數原料仍在竄動。發酵完畢：液面原料沉入缸底，料液處于靜止狀態，并由渾濁變清。進入發酵完畢期即可蒸餾。

6. Fermentation process. In the early stage of fermentation: the liquid surface is filled with bubbles, and later small bubbles are as big as soap bubbles. The raw materials move up and down, causing the wine to become turbid when stirred. Fermentation decline period: The bubbles on the floating surface of the raw materials decrease, and a few raw materials are still moving. Fermentation completed: The liquid surface of the raw material sinks into the bottom of the tank, and the material liquid is in a static state, changing from turbid to clear. Distillation can be carried out once the fermentation is completed.